Auraton 2005 инструкция на русском скачать

1. Manuals
2. Brands
3. AURATON Manuals
4. Thermostat
5. 2005
6. User manual

• Page 1
  2005 2005 TX RX Plus…
• Page 2
  Communication code of AURATON 2005 TX Plus AURATON 2005 can be manually set by user. The factory set communication code is «085». If there are troubles with communication between AURATON 2005 TX Plus and RX Plus the code can be changed (Manual, page 41).
• Page 3
  AURATON 2005 — Installation Avoid close to some heat generating appliance (e.g. 1. Installation instructions TV, heater, refrigerator) or exposed to direct sun AURATON 2005 light. Do not install near a door where the Caution: Switch off the electric source before thermostat will suffer from vibration.
• Page 4
  AURATON 2005 — Installation 1.2 Wiring Fix the thermostat by putting it over the screwhead AURATON 2005 and slide it rightward (note the keyhole like opening Wiring terminals are at the back of the thermostat. at the back of the thermostat). Tighten the remain Press down the terminal cover, you can find three screw to lock it in place.
• Page 5
  AURATON 2005, AURATON 2005 TX Plus — Familiar with your AURATON 2.2 Temperature mode 2. Familiar with your AURATON 2005 You can see «A » and «B » on both the buttons AURATON 2005 TX Plus and the LCD. «A «…
• Page 6
  AURATON 2005, AURATON 2005 TX Plus — Familiar with your AURATON If you remove the front cover, you can find three 2.5 LCD small switches (dip switches). These three switches are used to control the span, output-on delay and heat/cool system. Span is the temperature (1 C or 0,5 C) difference between the turn on temperature and turn off temperature.
• Page 7
  AURATON 2005, AURATON 2005 TX Plus — Familiar with your AURATON Note: The LCD after start or reset. A. The output-on indicator will be displayed if the output is on. It will disappear if the output is off. B. The low battery indicator will be displayed if the voltage of the batteries drop to a certain level.
• Page 8
  AURATON 2005, AURATON 2005 TX Plus — Familiar with your AURATON 2.7 Set day/time Note: A. The temperature setting range is 5 to 30 C. To set day, press «d» button. Similarly, press «h» button to set hour and «m» button to set minute.
• Page 9
  AURATON 2005, AURATON 2005 TX Plus — Familiar with your AURATON 2.9 View/Change programs PROG Press «Prog» button, the program of the current day is ready to be changed. PROG Press «Prog» button again can advance to the next day and the program of that day will be shown.
• Page 10
  AURATON 2005, AURATON 2005 TX Plus — Familiar with your AURATON Example: Since we want to set 13:00 to 18:00 to comfort temperature and the remains to economy A. Assume you want to assign program 6 to temperature, press 13 times. 00:00 to 12:00 will…
• Page 11
  AURATON 2005 TX RX Plus — Installation 3. Installation instructions F. Press OK or leaving no key pressed for 15 seconds, the thermostat will return to normal AURATON 2005 TX RX Plus operation mod. Programmable Temperature Controller AURATON Note: Programs 0, 1, 2, 3, 4, 5 are preset…
• Page 12
  AURATON 2005 RX Plus — Appearance 3.1 Connecting AURATON 2005 RX Plus 4. Appearance of to a heating device AURATON 2005 RX Plus Warning: Unplug heating device from power supply before mounting receiver. Find connectors on the back of AURATON 2005 RX under the plastic cover.
• Page 13
  AURATON 2005 TX RX Plus — Turning on for the first time 1. Antenna for communication with AURATON 5. Turning on AURATON 2005 TX RX 2005 TX Plus for the first time Plus green LED – indicates operating status of heating device 1.
• Page 14
  AURATON 2005 TX RX Plus — Setting communication code Notes: 4. Press and hold «PROG#» again to set new communication code (range between 001 to will not receive ON/OFF AURATON 2005 RX Plus 255). signal from for 5 minutes AURATON 2005 TX Plus 5.
• Page 15
  AURATON 2005 — How to connect 8. How to connect AURATON 2005 How to connect directly to AURATON 2005 a heating device. HEATING DEVICE AURATON 2005…
• Page 16
  AURATON 2005 — How to connect How to connect to single- AURATON 2005 phase heating device with working load exceeding 5A thought magnetoelectric relay. MAGNETOELECTRIC RELAY HEATING DEVICE AURATON 2005 POWER SUPPLY max ~220V…
• Page 17
  AURATON 2005 — How to connect How to connect to three- AURATON 2005 phase heating device through three-phase contactor. THREE PHASE CONNECTOR HEATING DEVICE AURATON 2005 max ~220V…
• Page 18
  AURATON 2005 — How to connect How to connect directly to AURATON 2005 gas water heating device powered by ~220V and equipped with circulating pump. WATER AURATON-2005 DEVICE max ~220V 5A ~220V CIRCULATING PUMP…
• Page 19
  AURATON 2005 TX RX Plus — How to connect How to connect AURATON 2005 TX RX Plus with a heating device Ni Po Wt Śr Cz Pt So PROG HEATING DEVICE (receiver) AURATON 2005 RX Plus AURATON 2005 TX Plus…
• Page 20
  AURATON 2005, AURATON 2005 TX RX Plus — Specification 9. Switching 9. Specification 230VAC 50Hz 5A resistive 1. Temperature measurement range 10. Dimensions 0-34.75 C (0,25 C step) 154 x 80 x 30 (mm) (W x H x D) 2. Temperature control range 11.
• Page 23
  Urządzenia objęte instrukcją są oznaczone zgodnie z Dyrektywą Europejską 2002/96/WE oraz polską Ustawą o zużytym sprzęcie elektrycznym i elektronicznym symbolem przekreślonego kontenera na odpady. Takie oznakowanie informuje, że sprzęt ten, po okresie jego użytkowania nie może być umieszczany łącznie z innymi odpadami pochodzącymi z gospodarstwa domowego. Użytkownik jest zobowiązany do oddania go prowadzącym zbieranie zużytego sprzętu elektrycznego i elektronicznego.
• Page 24
  Serwis: tel 061 840 40 55 (pn.- pt. 8.00-16.00) WWW.AURATON.PL AURATON 2005 Warunki Gwarancji: AURATON 2005 TX RX Plus 1. Gwarancji udziela się na okres 36 miesięcy od daty sprzedaży. 2. Reklamowany regulator wraz z kartą gwarancyjną, należy dostarczyć do punktu sprzedaży za pośrednictwem poczty (w przypadku sterownika…

Ваш е-мэйл

Заполните, если хотите получить ответ

Оцените наш проект

1

2

3

4

5