Blomberg gss 1380 x инструкция

3/4”

min 10

AQUASAFE+

2118

AQUASAFE+ (depends on the model)

The Aquasafe+- system protects you from water damage which may be caused at the water inlet hose.

Do not immerse the system’s valve box into water; it contains electrical components.

In case of damage, pull out the power supply plug. Do not shorten or lengthen the hose insert, since it contains electrical cables and components.

Water drainage

Connecting the drainage hose.

Take care to ensure that the water intake hose is not bent or squeezed.

Check that the drainage hose is firmly seated in place.

Extension hoses

If a hose extension is required, a drainage hose of equal quality must be used

The maximum length must not exceed 4m. Otherwise, the machine’s cleaning process is negatively influenced.

Siphon connection

The drainage height must be between 50 and 100 cm above the floor.

Use hose clamps to fasten the drainage hose to the siphon.

Electrical connection

Please refer to the type plate for information on current type, mains voltage, and fuse protection.

The type plate is located on the inside of the door.

The mains plug must be freely accessible after installation. Power cables and insulated cables must not be accessible after installation.

11 Service

If your machine ever experiences faults in operation, check the notes and advice in the operating manual.

If this does not fix the problem, our customer service staff is available to you.

Dear customer,

Before starting, it is essential that you read carefully right through the installation and operation instruction booklet before plugging in to the mains socket. The following instructions should prevent the risk of personal injury and/or damages to the machine.

Please keep these documents for later reference in a safe place.

This operating manual has been written for different machines and some of the features mentioned here may not apply to your specific machine.

3/4”

min 10

3/4” 1/2” CH

DK

S

3/4” N

SF

Installing your dishwasher

Choose a suitable location for your dishwasher. Take care to ensure that the machine is standing safely and levelly.

Unevenness in the floor can be equalised by adjusting the screw feet. When the machine is standing correctly, the door can be closed without difficulties.

Water inlet and drainage hoses must be placed so that they can move freely in order to avoid bending or squeezing them.

The machine may not be hooked up in rooms with a temperature below 0° Celsius.

Water connection

The dishwasher may be connected to cold and warm water to a max. temperature of 60° Celsius.

The dishwasher may not be connected to open warm water devices and flow-through water heaters.

Permissible water pressure:

Connect water inlet hose

Take care to ensure that the water inlet hose is not bent or squeezed. Do not install a used hose set.

Use a screw-on hose connector to connect the water inlet hose to a water tap with an external thread with a measurement of 3/4 inches.

If required, use a filter inset to filter deposits from the pipes.

Check that the connection does not leak.

Attention

For safety reasons, close the tap after every rinse process.

22

9 Technical features

Because we continually strive to improve our products, we may change our specifications and designs without prior notice.

This device corresponds to the following EU Directives:

10 Directions for assembly

Safety notes for installation

Prior to installing and using your machine, please check it for possible transport damage.

If the machine is damaged, please contact your supplier. Never install and use damaged machines.

The following directions must be observed in order to connect the dishwasher properly.

Make sure that the data on the type plate correspond to the current and voltage of your power supply connections before putting the machine into operation. The connection of the machine may only be made using a properly grounded socket. Ensure that the grounding is in accordance with regulations.

The grounded socket must be easily accessible and close to the machine.

Do not use extension cables or multiple adapters.

There is a possibility of fire hazard through overheating.

Hardwiring may only be carried out by a qualified electrician.

Check the power cable, the water inlet hose and the drainage hose. Damaged parts may only be exchanged by customer service personnel or by a qualified electrical service expert.

2

1 Disposal

Recycling

The packaging and some parts of your machine are made from recyclable materials. These materials are marked up with recycling symbol and material type information (PE, PS, POM).

Remove the packaging material and dispose of it in accordance with regulations prior to taking the machine into operation.

Warning

Packaging materials may be dangerous to children. Reusable substances may be dropped off at the local disposal facilities. You may obtain further information from the authorities and disposal facilities.

Disposal of your old machine

Dispose of your old machine in accordance with the disposal guidelines which are in effect at the location where you reside. To avoid dangers, please make the machine unusable until the time of transport.

Pull out the mains plug and cut the power cable. Render the door lock unusable.

2 Safety Instructions

Before installation

Check the machine for transport damages. Never install and use damaged machines. If in doubt, contact your supplier.

Before first use

See Notes for Installation on page 22.

Have the grounding system installed by a qualified electrician.

The manufacturer cannot be hold liable for any damages that are due to operating the machine without proper grounding.

Before operating the system, please check that the data given on the type plate are in accordance with the data of your power supply.

The dishwasher must be separated from the mains during installation.

1

2

3

4

5

6

7

8

9

10

11

12

• Page 9
  — Note — — Note -…
• Page 10
  Three-in-one: Two-in-one:…