Bosch maxx 4 wfc 1200 инструкция

• Page 1
  Maxx4 WFC1200 en Instruction Manual and Installation Instructions Internet: http://www. bosch-hausgeraete.de…

• Page 2: Table Of Contents

  Table of Contents Safety Instructions ……Operating Before Using Your Washing Machine Instructions For the First Time .

• Page 3: Safety Instructions

  Please read this instruction manual and all other infor mation accompanying the washing machine before operating the appliance. Please retain all documents for future reference or for a subsequent appliance owner. Safety Instructions Your washing machine is intended: General — For domestic use only. — For washing machine washable fabrics in washing lye.

• Page 4: Control Panel

  Control panel 1. Select a programme Can be turned in both directions. Switches on / off the washing machine. The programme selector cannot be turned when the programme is in progress. The programme sequence is controlled electronically. 2. Control lights illuminate H End»…

• Page 5: Before Using Your Washing Machine For The First Time

  Before Using Your Washing Machine For the First Time…

• Page 6: Preparing, Sorting And Loading The Laundry

  Preparing, Sorting and Loading the Laundry Caution Preparing Loose debris (e.g. coins, paper clips, needles, nails) the laundry can damage items of clothing as well as parts of the washing machine (e.g. drum). q Empty all pockets on items of clothing. q Brush out any sand from pockets and cuffs.

• Page 7
  d Risk of explosion! Loading the laundry Items of clothing that have been pretreated with solvent based cleaning agents, e.g. stain remover and dry cleaning spirit, represent an explosion hazard once loaded into the washing machine. Therefore, these items must first be rinsed thoroughly by hand. Caution Loose debris in the washing machine drum can damage the laundry.

• Page 8: Laundry Detergents And Additives

  Laundry Detergents and Additives d Risk of poisoning! Dispensing the Keep detergents and additives out of the reach correct amount of children. of detergent Dispense the detergent according to: q the water hardness. This information can be obtained from your local water authority. q the amount of laundry.

• Page 9: Selecting Programmes

  Selecting Programmes Basic programmes Select the desired programme (refer also to separate Programme Chart»). 90 C Cottons + Linens An energy intensive programme for heat resistant fabrics made from cotton or linen. For the protection of the drainage pipe, the hot washing solution is mixed with approx.

• Page 10
  Extra cycle Rinse programme selector Separate rinsing cycle with subsequent spin cycle for easy care fabrics. Spin Separate spin cycle. Washing solution or rinsing water is drained prior to the spin cycle. Drain Draining of the rinsing water after a wash programme with the C Rinse hold»…

• Page 11: Washing

  Washing q Turn on the water tap. Start the q Turn the programme selector to the desired programme programme (refer also to separate Programme Chart»). The  Ready» control light comes on. q Where required, press the option button(s) for additional function(s).

• Page 12: When The Programme Has Ended

  When the Programme has Ended The  End» control light comes on. q Turn the programme selector to  Off», and, where required: q Select a programme option ( Drain»,  Spin» or r Rinse»). q Press the  Start» button. q At the end of the programme option, turn the programme selector to  Off».

• Page 13: Special Applications

  Special Applications Pre soak Starching…

• Page 14: Cleaning And Care

  Cleaning and Care d Risk of electric shock! Always disconnect the appliance from the mains before cleaning. Never clean the washing machine with a jet of water. d Risk of explosion! Never use solvents to clean the appliance. As required: Cleaning the q Use hot soapy water or a mild, non abrasive appliance housing…

• Page 15: Detergent Dispenser

  In the event that residual detergents or additives have Cleaning the accumulated: detergent dispenser q Pull out the detergent dispenser up to the end stop, press down the hollow on the insert and remove the detergent dispenser completely. q Pull up the insert. q Rinse the detergent dispenser under hot running water.

• Page 16
  Cleaning the drain pump Draining the washing solution d Risk of scalding! 90 °C max.
• Page 17
  This is necessary if very little or no water flows into the Cleaning water inlet washing machine. strainers First release the water pressure in the supply hose: q Turn off the water tap. q Turn the programme selector to any programme (except  Spin»…

• Page 18: Troubleshooting Minor Faults

  Troubleshooting Minor Faults d Risk of electric shock! Repairs must only be carried out by our Customer Service or an authorized technician. If repairs are needed, and assuming that you cannot eliminate the fault yourself with the aid the following table: q Turn the programme selector to  Off».

• Page 19
  Fault Cause Action…
• Page 20
  Fault Cause Action Repeated spinning at This is not a fault. short intervals. The imbalance compensation system is attempting to balance the load through repeated spins. The degree of dirt was higher than Select a more suitable programme. Unsatisfactory washing supposed.

• Page 21: Customer Service

  Customer Service Before calling the Customer Service, please make sure that you cannot eliminate the fault yourself (refer to Page 18). This is because consultation provided by our techni cians, even within the warranty period, will lead to costs being incurred by yourself. Your nearest Customer Service centre can be found in the index supplied.

• Page 22: Consumption Rates

  Consumption Rates Normal programme Load Consumption rates ** (without additional (without additional Electricity Water Duration functions)

• Page 23: Installation, Connection And Transport

  Installation, Connection and Transport d Risk of injury! Safety information The washing machine is heavy. Take care when lifting it. Caution Frozen hoses can tear / burst. Do not install the washing machine outdoors or in an area prone to frost.

• Page 24
  Useful tools Dimensions…
• Page 25
  Installation area Built under or built in appliance installation Caution…
• Page 26
  Caution Removing the The transport bolts must always be removed before transport bolts using the appliance for the first time and must be retained for any subsequent transport (e.g. when moving). q Loosen all four transit bolts with the A/F 13 wrench until they are freely movable.
• Page 27
  Hose and cable lengths Left hand connection Right hand connection Other hoses Available from specialist dealers: — Extended supply hose (approx. 2.20 m).

• Page 28: Water Connection

  Water connection Water supply Caution The washing machine must only be operated with cold tap water. Do not connect the appliance to the mixer tap of an unpressurized hot water boiler. If in any doubt, have the water connection carried out by an authorized technician.

• Page 29: Levelling Procedure

  Water drainage Caution Do not bend or pull the water drainage hose. Height difference between the placement area and drainage point: Minimum 60 cm, maximum 100 cm. Drainage into a siphon: q Secure the connection point with a hose band clip of 24 40 mm dia.

• Page 30
  Caution Electrical The washing machine must only be connected to connection alternating current and using a properly installed socket outlet with earthing contact. The mains voltage must correspond to the voltage specification on the washing machine (nameplate). Connection specifications as well as the required fuses are stipulated on the appliance nameplate.
• Page 31
  Before transporting the washing machine: Transport, — Turn off the water tap, e.g. when moving — Drain any residual washing solution (refer to Page 16), — Release the water pressure in the supply hose (refer to Page 17), — Disconnect the washing machine from the mains. — Dismantle the supply and drainage hose, — Install the transport bolts.
• Page 32
  Printed in Germany PW/ED1-M 0401 en 5550 005 227 ROBERT BOSCH HAUSGERÄTE GMBH…

Bosch WFC 1200 инструкция по эксплуатации
(33 страницы)