Как сделать пушку из лего инструкция

Introduction: How to Make a Basic Lego Artillery Gun

this instructable will show you how to make a basic Lego artillery gun. This is a very simple model to make and is also very powerful. The gun can be used to shoot Lego minifigures and other Lego models. This will show you how to make a basic frame and then you can build the rest any way you like it.

Step 1: What You Need:

Step 2: Base Levels1,2&3

get a lot of pieces and build a structure like in the pics or if you don’t have enough bricks just build a three brick high tower.

Step 3: Now Add the Spinning Piece

add the spinning piece to the base.

Step 4: Start Making the Gun

Take a 2×7 plate and attach it to one side of the joint and a 4×6 plate on the other two knobs on the joint like in the picture.

Step 5: Making the Cannon Part 1

Take a 2×4 plate and attach the two 4×4 click connector plates to the top. Then take two click and rod combo connector pieces and attach the click holes to the click plates. Next take the cannon and slide it over the two grey connectors with the + hole parallel with the cannon. Finally take the two red cross connectors and slide them through the cannon and the grey connectors to attach it to the two plate connectors.

Step 6: Making the Cannon Part 2

Take 4 click and rod combo connectors and attach the long end of the grey click connectors to the click side of the connectors. Then take the connectors and put the snap into the holes closest to the red cross connector on the cannon , repeat on the other side. Next take the two medium rods with the studs on the end and slide them into the cross holes on the cannon assembly with the stud part at the front of the cannon. Finally put the two cones on the studs on the rods to make smaller guns.

Step 7: Mounting the Cannon

Attach the cannon to the joint assembly as shown in the picture, then attach the joint and cannon to the base turn table as shown.

Step 8: Extended Trigger (optional)

this step is optional but if you decide to put full armor on it like in the picture it is recommended. take the long rod and attach the hole part of the black connector to the stud then put the rod hole on the trigger.

Step 9: Your Done!