Мотопомпа fubag 950t инструкция по эксплуатации

www.fubag.ru

Operator’s manual

www.fubag.ru

WARNING!

—Always make a pre-operation inspection before you start the engine. You may prevent an accident or equipment damage.

—Know how to stop the pump quickly and understand operation of all the controls. Never permit anyone to operate the pump without proper instructions.

—Keep children and pets away from the pump when it is in operation.

—Failure to carry out measurements and checks for early detection of defects.

—The rated speed of the motor has been set during manufacture and may not be changed.

—No naked flames, lights or spark-emitting appliances may be used within the hazard area of the pump.

—Smoking within the hazard area of the pump is strictly forbidden.

—The pump may only be transported when cold.

—The pump may only be lifted using the carry handles intended for this purpose.

—The appliance may not be covered. The air intake may not be blocked or obstructed.

—All other servicing and repair work may only be carried out by personnel who are qualified and licensed for this purpose.

—Always remove spark plug connector prior to commencing servicing and repair work.

—The service intervals set out in these instructions must be observed.

—The pump must be shut down when not required for periods longer than 30 days.

—The pump must be stored in a dry enclosed room.

— 2 —

Operator’s manual

www.fubag.ru

2. Description

START

CHOKE

ON

OFF

1.Fuel tank plug

2.Pump filler cap

3.Choke

4.Motor contactor

5.Throttle lever

6.Fuel tap

7.Recoil starter

8.Pump drain plug

9.Air filter

10.Spark plug

11.Exhaust silencer

— 3 —

Operator’s manual

www.fubag.ru

3. Specifications

The manufacturer reserves himself the right to make the manual’s content or pump function change without any preliminary notification of the users.

4. Preparation before use

Positioning for operation

Place the motor pump on a sufficiently strong, flat and horizontal surface so that the electric pump cannot sink in (the inclination must not exceed 10° in any direction).

Select a clean location, ventilated and protected from inclement weather, and provide an oil and fuel supply close to the place of motor pump usage, while still maintaining a safe distance.

Select a location which will not impede the movement of people or vehicles.

Make sure that the motor pump remains stable and immobile while in operation. Don’t forget that the suction hose tends to pull the motor pump towards the water source during pumping.

Place the motor pump as close as possible to the liquid being drawn-in. The shorter the vertical distance between the motor pump and the liquid surface, the more rapid the priming and the greater the volume of liquid pumped.

Submerge the strainer completely within the liquid, taking care that it is not blocked.

— 4 —

Operator’s manual

www.fubag.ru

Oil level

1.Remove the filler plug-dipstick (no. 2) by unscrewing it, and wipe the dipstick.

2.Insert the dipstick into the filler neck (no. 3) without screwing it. N.B.: A second black plug (no. 4) without a dipstick, is available if necessary on the other side of the engine.

3.Visually check the level and top up if necessary.

4.Tighten the filler plug-dipstick (no. 2) completely onto the filler neck (no. 3).

5.Check that there are no leaks.

6.Wipe off excess oil with a clean cloth.

— 5 —

• www.fubag.ru Инструкция по эксплуатации -3 -2 5. Проверьте состояние шайбы. 6. Установите на место свечу зажигания и заверните ее от руки, чтобы не повредить резьбу. 7. Доверните свечу с помощью свечного ключа на 1/8 — 1/4 оборота, чтобы сжать шайбу. 1. Удалите пыль и за�

• www.fubag.ru Инструкция по эксплуатации ВНИМАНИЕ! ПЕРЕД ИСПОЛЬЗОВАНИЕМ МОТОПОМПЫ ВНИМАТЕЛЬНО ОЗНАКОМЬТЕСЬ С ДАННОЙ ИНСТРУКЦИЕЙ. К использованию и обслуживанию мотопомпы допускается только квалифицированный и специально обученный персонал, ознакомленный с данной инструкцией. В этой инст�

• — 5 — Oil level 1. 2. 3. 4. 5. 6. Remove the filler plug-dipstick (no. 2) by unscrewing it, and wipe the dipstick. Insert the dipstick into the filler neck (no. 3) without screwing it. N.B.: A second black plug (no. 4) without a dipstick, is available if necessary on the other side of the engine. Visually check the level and top up if necessary. Tighten the filler plug-dipstick (no. 2) completely onto the filler

• www.fubag.ru Инструкция по эксплуатации -7 -1 Уровень масла 1. Отвинтите и извлеките пробку-щуп заправочного отверстия ( поз. 2) и вытрите щуп. 2. Вставьте щуп в заправочную горловину (поз. 3) не заворачивая его. Примечание: В случае необходимо�

• www.fubag.ru Инструкция по эксплуатации — 19 — 5. Эксплуатация Запуск Работа помпы Перед запуском двигателя всегда заливайте в насос воду. Наличие жидкости необходимо для начального заполнения насоса и его смазки. 1. Полность�

• www.fubag.ru Инструкция по эксплуатации -5 -1 2. Описание 1. Крышка топливного бака 2. Крышка заливочного отверстия насоса 3. Рычаг воздушной заслонки 4. Включатель двигателя 5. Газовый рычаг 6. Топливный кран 7. Пусковой шнур 8. Крышка слива насоса 9. Воздушный фильтр 10. Свеча зажига

• www.fubag.ru Инструкция по эксплуатации — 18 — Уровень топлива Используйте только чистое топливо без примеси воды. Не переполняйте топливный бак (внутри заправочной горловины не должно быть топлива). После заливки топлива убедитесь, что пр�

• — 3 — 2. Description 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. Fuel tank plug Pump filler cap Choke Motor contactor Throttle lever Fuel tap Recoil starter Pump drain plug Air filter Spark plug Exhaust silencer www.fubag.ru Omperator’s anual START ON CHOKE OFF
  

• — 11 — 5. 6. 7. 1. 2. 3. 1. 2. 3. 4. 5. 6. 7. 8. Check the condition of the washer. Fit the spark plug in position and tighten it by hand to avoid damaging the threads. Use a spark plug spanner to tighten it by 1/8-1/4 turn after it is seated to compress the washer. Remove all dust and particles around the exhaust silencer. Clean the motor pump, especially the air inlets & outlets of the engine, with a cloth and a brush. Check the general condition of the motor pump and if change any defective parts. If the pump is not

• — 6 — Fuel level Only use clean fuel without any water. Do not overfill the tank (there should not be any fuel in the filler neck). After filling, always check that the plug is fitted properly on the tank. If fuel has been spilled, make sure that it has dried and that the fumes are dissipated before starting the motor pump set. Visually check the fuel level. Top up if necessary: Close the fuel tap. Remove the fuel tank plug.

• — 12 — 8. Trouble Shooting www.fubag.ru Omperator’s anual FAULT POSSIBE CAUSE REMEDY Air filter clogged up. Clean the air filter. Fuel tap closed. Open the fuel tap. Fuel level too low Fill up with fuel. Fuel filter clogged up. Clean the fuel filter. Oil level too low. Check the oil level and top up if necessary. Fuel supply blocked or leaking Have it checked, repaired or replaced.* Engine not starting Spark plug defective. Check the spark pluga

• — 8 — Switching off O Rinsing Safety features 1. 2. 3. 1. 2. 3. 4. 5. 6. 7. 8. Restore the gas lever to its original position. Set the engine switch to the “ ” position. The motor pump stops. Drain the motor pump then rinse it if its use is over for the day. Once the motor pump is shutdown and cold: Empty the suction & discharge hoses, allow the liquid to drain out. Unscrew the drain plug from the pump in order to drain-out the pump housing. Screw the pump drain plug back on once draina